A few people have been asking if I would make wireless charging kits available for purchase. I figured I'd start a thread to gauge interest.
It consists of a 3D printed tray (in PETG) upholstered in Alcantara with a built-in MagSafe Charger that replaces the OEM rubber mat in the center console. It also uses a standalone USB power supply that provides enough power to effectively charge the phone (the usb-c port under the center console does not which causes the phone to charge very slowly). Power is fed via an unused OEM 12v power source behind the glovebox, no splicing needed.
Now, it is not inexpensive so I understand this is not everyone. Price would be $300 + shipping. I would need a minimum of 10 people and a 50% deposit. Lead time would be 6-8 weeks (realistically probably less but I rather underpromise and overdeliver)
You will get:
1. @Rapture
2.
3.
4.
5.
6.
7.
8.
9.
10.
More info/disclaimers:
- I tested this on an iPhone 14, 14 pro and 15 pro.
- Just as with any other MagSafe charger, you need a MagSafe compatible case or no case for this to work properly.
It consists of a 3D printed tray (in PETG) upholstered in Alcantara with a built-in MagSafe Charger that replaces the OEM rubber mat in the center console. It also uses a standalone USB power supply that provides enough power to effectively charge the phone (the usb-c port under the center console does not which causes the phone to charge very slowly). Power is fed via an unused OEM 12v power source behind the glovebox, no splicing needed.
Now, it is not inexpensive so I understand this is not everyone. Price would be $300 + shipping. I would need a minimum of 10 people and a 50% deposit. Lead time would be 6-8 weeks (realistically probably less but I rather underpromise and overdeliver)
You will get:
- 3D printed tray upholstered in genuine Alcantara (matches OEM. Pictures below are of V1.0, I need to make a couple of changes for better fitment)
- Authentic Apple MagSafe Charger.
- Wiring harness with plug-and-play connectors (uses factory harness behind glovebox)
- Dual port (1x USB-C, 1x USB-A) power supply (may end up using something other than what's pictured. I would like it smaller in a custom housing)
- Installation instructions.
1. @Rapture
2.
3.
4.
5.
6.
7.
8.
9.
10.
More info/disclaimers:
- I tested this on an iPhone 14, 14 pro and 15 pro.
- Just as with any other MagSafe charger, you need a MagSafe compatible case or no case for this to work properly.
Last edited: